EaganMatrix
Thumbnails for user-defined formulas

item2a

Matrix

In the EaganMatrix, patch sources are on the left of the matrix, and patch destinations are above the matrix. To make a connection, a value or formula is inserted in the intersection point of the source and the destination.

EaganMatrix
A section of the matrix, showing a highlighted connection: Direct + using Formula C into Oscillator 3 frequency

 

Connection points can use a wide variety of constants, predefined formulas, or user-defined formulas. Usage of user-defined formulas can be monitored in the Formula thumbnail area of the EaganMatrix, pictured to the left on this page.

In the picture below, the highlighted patch point shows a constant of 1 patched from Oscillator 2 source to LowPass filter 1 input, allowing the audio from the Oscillator to go directly into the filter without influence from the playing surface.

EaganMatrix
A section of the matrix, showing a highlighted connection: Osc 2 using Constant 1 into Low Pass filter 1 input

 

The connection highlighted below shows a predefined Formula, Z, being used to control the audio output of Filter 1 into the right input of the Master section. Formula Z is a predefined mapping of the Continuum surface, only using the pressure (Z) value from finger placement. Used this way the finger acts as a volume control for the filter level.

EaganMatrix
A section of the matrix, showing a highlighted connection: Filter 1 using Predefined formula Z into Audio Right out


 

 

 

EaganMatrix

Examples